User Manual

computer radio control system
EN
b. Ailerons/Flaps Adjustment
In the Ailerons/Flaps Adjustment menu you can set all the travel
needed for butterfly braking (for the flaps and ailerons). Also, you
can set a parameter called Diff. adjust which influences the aileron
differential. Positive values increase the upper travel of the aileron
servos, negative values increase the lower travel of the aileron
servos.
Actual values of
airbrake rates.
T h e v a l u e s
shown depend
on adjustments
m a d e i n
Butterfly Tuning
m e n u (see
below).
c. Elevator compensation
The butterfly mixing is always from zero to the full stick position so
the curve is a little bit modified to control the whole travel range. You
can choose between a standard curve, constant and X-point curve
types.
d. Butterfly Tuning menu
Screen of the Butterfly menu allows you to fine tune all braking
travels through one proportional control (stick, knob or switch). The
values you set in this screen are added/subtracted to the
appropriate butterfly travels. The way these values influence servo
deflections depends on the position of the butterfly's control stick
and the position of the butterfly's Tuning control.
The „F(3)Apply” button operates similarly as in the Aileron
Differential menu. If you press this button, the values set in the
„Butterfly Tuning” menu are copied into the appropriate travels in
the „Butterfly Ailerons/Flaps/Elevator Adjustment” menu. After
that, all values in the Butterfly Tuning menu are initially set to zero (so
that the tuning control no longer has an effect).
4. 4.