User Manual
Table Of Contents
- Manufacturer: Esprit Model
- DC-DS-16-EN-Part 1.pdf
- DC-DS-16-EN-Part 2.pdf
- Stránka 18
- Stránka 19
- Stránka 20
- Stránka 21
- Stránka 22
- Stránka 23
- Stránka 24
- Stránka 25
- Stránka 26
- Stránka 27
- Stránka 28
- Stránka 29
- Stránka 30
- Stránka 31
- Stránka 32
- Stránka 33
- Stránka 34
- Stránka 35
- Stránka 36
- Stránka 37
- Stránka 38
- Stránka 39
- Stránka 40
- Stránka 41
- Stránka 42
- Stránka 43
- Stránka 44
- Stránka 45
- Stránka 46
- Stránka 47
- Stránka 48
- Stránka 49
- Stránka 50
- Stránka 51
- Stránka 52
- Stránka 53
- Stránka 54
- Stránka 55
- Stránka 56
- Stránka 57
computer radio control system
EN
4. 4.
3. Global or Separate Function Curve Setting
The function curve configuration for all channels can be set
collectively for all flight modes by selecting the “G-Global (globe)”
symbol or you can set individual function curve settings in each
separate flight mode by sellecting the “S-Separate” symbol.
9.2.6 Aileron Differential
The aileron differential function reduces the downward travel of the
aileron(s) to help eleminate any adverse yaw tendencies in rolling
maneuvers. Semi-Symmetrical airfoils with an aileron in the down
position induce higher drag than when the aileron is in the up
position. Therefore, the aileron travel up and down has to be set
differently. The number of aileron servos displayed depends upon
the selected wing type of your airplane; the maximum number is
four “S1-S4”.
1. Aileron Differential Global or Separate Setting
The aileron differential for all channels can be set collectively for all
flight modes by selecting the “G-Global (globe)” symbol or you can
allow individual aileron differential settings in each separate flight
mode by sellecting the “S-Separate” symbol.
2. Aileron Differential Setting
All of the ailerons can have different travel ranges. The different
adjustments are displayed in columns marked „S1-S4”. The number
of servos in use is equal to the number of displayed setup columns.
The travel range for each servo can be set. Scroll and highlight either
the “Up” or “Down” menu line with “3D Control” button. Press the
„3D Control“ button to access and edit the settings for each servo. If