User Manual

computer radio control system
EN
4. 4.
9.2.5 Programmable Function Curves
Function curves define the relationship between the actual position
of your stick/switch/knob and the position of the servo. This screen
displays the menu of all assigned functions , graphic interfaces
(a)
(b) (c)
, and programmable time delays . All adjustments can be
visually inspected right away in the servo monitor page by pressing
the “F2 (Servo)” button.
a) Function name.
Graphic interfaces.
b)
Time delay.c)
Global or Separate setting.d)
e) Flight Mode Delay Enable
1. Programming Function Curves
The Function Curves programming screen can be accessed by
highlighting “Curve” window and pressing “3D Control” button or
directly accessed by simply pressing “F4” button. Either way, you will
be taken to the highlighted function’s curve option screen.
c
a
b
e
Flight Mode Delay Enable
In the menu Fine Tuning->Function Curves, it is possible to
activate/deactivate a delay for a specific function while switching
between flight modes. Specifically, in the picture, it is the 5th column
(FM. Delay) that allows this. The activation of a delay also might be
flight-mode specific (i.e.: in first flight mode the delay is activated
and in the second mode it is disabled). There are some specific
conditions where setting this option for one function has an effect in
another function.
• If V-Tail is selected, the option influences both rudder and
elevator.
• If Delta wing is selected, the option influences both elevator
and aileron.
• If electronic heli swash mix is selected, the option influences all
functions of the swash plate (roll, pitch, and elevator).
b
a
a)
Function curve type.
b) Graphic interface.