User Manual
Table Of Contents
- Manufacturer: Esprit Model
- DC-DS-16-EN-Part 1.pdf
- DC-DS-16-EN-Part 2.pdf
- Stránka 18
- Stránka 19
- Stránka 20
- Stránka 21
- Stránka 22
- Stránka 23
- Stránka 24
- Stránka 25
- Stránka 26
- Stránka 27
- Stránka 28
- Stránka 29
- Stránka 30
- Stránka 31
- Stránka 32
- Stránka 33
- Stránka 34
- Stránka 35
- Stránka 36
- Stránka 37
- Stránka 38
- Stránka 39
- Stránka 40
- Stránka 41
- Stránka 42
- Stránka 43
- Stránka 44
- Stránka 45
- Stránka 46
- Stránka 47
- Stránka 48
- Stránka 49
- Stránka 50
- Stránka 51
- Stránka 52
- Stránka 53
- Stránka 54
- Stránka 55
- Stránka 56
- Stránka 57
computer radio control system
EN
After you make a configuration change or perform a
reset, always check all flight modes.
Advice:
9.2.2 Digital trim
Fully programmable digital trims are located right under transmitter
gimbals as a set of four directional buttons. All adjustments and step
changes are made in the “Digital Trim” menu. You can assign
different trim ranges and trim steps to every trim control function.
The “F3 (Trim)” button switches your desktop display to the main
trim screen where you can instantly observe your setup changes.
1. Digital Trim Programmable Steps
Trim step changes are made in the “Step” menu column, a larger
percentage number equals more movement with each press of the
trim button.
2. Trim Range
Trim range changes are made in the“Rate” menu columns which
show the trim’s percentage of possible travel. Both negative and
positive travel can be adjusted individually.
3. Global or Separate Trim Setting
The trim configuration for all main functions can be set collectively
for all flight modes by keeping the “G (globe symbol)” setting or they
can be set in each flight mode individually by selecting the “S-
Separate” setting.
For a maiden flight we recommend using larger trim
steps. After familiarizing yourself with your model’s
behavior you can switch to smaller steps for finer
trimming.
Advice:
9.2.3 Flight Mode Trims
This menu allows you to set the function output position (if needed)
for each flight mode individually. For example: if your elevator
needs to be raised in one of your flight modes but not the others.
Each function output can be set either globally or separately.
4. 4.
1. Servo Position
A transmitter output channel can be assigned to more than one
receiver output channel if needed. Adjusting the values in the
individual columns marked “S1-S4” will change the position of the
servo (surface) for each output function. The servo position is
displayed as a percentage of the total servo travel.
Pressing the “F3 (Clr)” button resets the highlighted line’s travel
values to 0%.
This is useful when you are setting up a new model from a copied
model and you want different flight modes.
1
2
3