User Manual
Table Of Contents
- Manufacturer: Esprit Model
- DC-DS-16-EN-Part 1.pdf
- DC-DS-16-EN-Part 2.pdf
- Stránka 18
- Stránka 19
- Stránka 20
- Stránka 21
- Stránka 22
- Stránka 23
- Stránka 24
- Stránka 25
- Stránka 26
- Stránka 27
- Stránka 28
- Stránka 29
- Stránka 30
- Stránka 31
- Stránka 32
- Stránka 33
- Stránka 34
- Stránka 35
- Stránka 36
- Stránka 37
- Stránka 38
- Stránka 39
- Stránka 40
- Stránka 41
- Stránka 42
- Stránka 43
- Stránka 44
- Stránka 45
- Stránka 46
- Stránka 47
- Stránka 48
- Stránka 49
- Stránka 50
- Stránka 51
- Stránka 52
- Stránka 53
- Stránka 54
- Stránka 55
- Stránka 56
- Stránka 57
computer radio control system
EN
1. Assignment of Transmitter Output Functions to Receiver
Channels
Select the required receiver channel and press the „3D button“.
Now you can choose which function you want assigned to the
selected receiver channel.
With the „F5(Next)“ button you will enter the next step of the
assistant which creates and stores the model into transmitter
memory.
a) The assistant asks you to confirm the creation of the model by
displaying the question „Create and select a model?“. If you answer
by pressing the „F1(No)“ button, the model will not be saved and
you will return to the assistant to continue with further
configuration of your model.
If you press the „F5(Yes)“ button, the model will be stored in the
memory and at the same time will be activated. After that, you are
automatically taken to the „Servo Setup“ menu. Your stored model
can, of course, at any time be configured by selecting the „Main
menu->Model“> „Servo Setup“ menu.
4. 4.
Once your model is created and activated you should
bind your receiver with the transmitter and then
proceed with „Servo Setup“.
Advice:
9.1.9 Servo Setup
This menu is for the additional tuning of output functions of the
transmitter->receiver channels->servos. The assignment of a
transmitter output function to a receiver channel is shown in the
upper part of the menu (first item below the menu description).
1. Display of a Receiver Channel Throw
In the upper part of the menu the actual throw of the selected
channel is displayed using a live graphic. If you make a change to
your setup in this menu, you will immediately see how the output
will be influenced by the change.
2. Selection of Receiver Channel
In the first position F1 in the lower bar you see the actual selected
channel. With the F2() or F3()buttons or by editing the item „Servo
#“ you will select the receiver channel which you intend to
configure.
3. Center (Subtrim)
With this item you can adjust the servo neutral position of the
selected receiver channel.