User Manual
Table Of Contents
- Manufacturer: Esprit Model
- DC-DS-16-EN-Part 1.pdf
- DC-DS-16-EN-Part 2.pdf
- Stránka 18
- Stránka 19
- Stránka 20
- Stránka 21
- Stránka 22
- Stránka 23
- Stránka 24
- Stránka 25
- Stránka 26
- Stránka 27
- Stránka 28
- Stránka 29
- Stránka 30
- Stránka 31
- Stránka 32
- Stránka 33
- Stránka 34
- Stránka 35
- Stránka 36
- Stránka 37
- Stránka 38
- Stránka 39
- Stránka 40
- Stránka 41
- Stránka 42
- Stránka 43
- Stránka 44
- Stránka 45
- Stránka 46
- Stránka 47
- Stránka 48
- Stránka 49
- Stránka 50
- Stránka 51
- Stránka 52
- Stránka 53
- Stránka 54
- Stránka 55
- Stránka 56
- Stránka 57
computer radio control system
EN
4. 4.
• „Mechanical“ - this swash plate type uses a single servo for
each flight function. This is the swash plate type to select if you are
using a flybarless controller.
Reverse swash plate orientation by 180°
The „Front servo position“ item is accessible only for the swash
plate type „3 servos (default 120°)“. If your helicopter requires, it is
possible with a single button to turn the swash plate configuration in
the setup by 180°.
Swash plate angle
The „Angle“ item is only accessible in the „3 servos (default 120°)“
swash plate type. The angle formed by swash plate points 1 - 2 and 1
– 3 can be configured by the user in 1° increments. This allows you to
fine tune your swash plate configuration as needed.
Rotation
The „Rotation“ Item is only accessible in the „3 servos (default
120°)“ and „4 servos (default 90°)“ swash plate types. This item
allows you to rotate the entire swash plate by a defined angle. This
allows you to add fine tune your swash plate as required by some
scale models.
Servo arm lengths (servo 1 – 4)
This item allows you move your swash plate control points either
closer to or farther away from the axis of rotation. This allows you to
compensate for any nonlinear servo movements.
Governor
In some helicopter setups a governor function is used for motor
control – this allows the motor to run at a constant speed
independantly from any collective pitch. If your model helicopter
setup includes a governor which can be controlled through the
receiver then switch on this function. once you enable this function,
the governor configuration becomes accessible in the „Fine
tuning/Gyro/Governor menu.
9.1.5 Swash mix
Here is where you set up the swashplate CCMP (=Cyclic/collective
pitch mixing) throws for Aileron, Elevator and Pitch. You can fine
tune each of these functions by changing their percentages. If
needed, you can reverse the throws by setting a negative
percentage.