User Manual
Table Of Contents
- Manufacturer: Esprit Model
- DC-DS-16-EN-Part 1.pdf
- DC-DS-16-EN-Part 2.pdf
- Stránka 18
- Stránka 19
- Stránka 20
- Stránka 21
- Stránka 22
- Stránka 23
- Stránka 24
- Stránka 25
- Stránka 26
- Stránka 27
- Stránka 28
- Stránka 29
- Stránka 30
- Stránka 31
- Stránka 32
- Stránka 33
- Stránka 34
- Stránka 35
- Stránka 36
- Stránka 37
- Stránka 38
- Stránka 39
- Stránka 40
- Stránka 41
- Stránka 42
- Stránka 43
- Stránka 44
- Stránka 45
- Stránka 46
- Stránka 47
- Stránka 48
- Stránka 49
- Stránka 50
- Stránka 51
- Stránka 52
- Stránka 53
- Stránka 54
- Stránka 55
- Stránka 56
- Stránka 57
computer radio control system
EN
2. Tail Assembly
The following tail option are available:
Type
Description
Standard 1H1V
Standard tail assembly with one horizontal control
(elevator) and one vertical control (rudder)
V-tail 2H
Traditional V-tail
Ailvator 2H1V
Tail assembly with two elevator servos and one
rudder servo
Standard 2H2V
Tail assembly with two elevator servos and two
rudder servos
None – Elevon/Delta
The model is controlled by the combined control of
the wing surfaces
None
Model without a tail assembly
3. Number of Engines/Motors in the model
You can select the number of engines/motors in the model. You can
select up to 4 engines/motors. You can then assign the control of
each throttle to a different receiver channel if needed.
4. Number of Spoiler Servos in the model
You can select up to 2 spoilers servos. You can then assign the control
of each spoiler to a different receiver channel if needed.
5. Number of Landing Gear Servos in the model
You can select up to 4 landing gear servos. You can then assign the
control of each landing gear servo to a different receiver channel if
needed.
Press the „F5(Next)“ button proceed to the next step of the menu
assistant: „Functions Assignment“.
4. 4.
9.1.4 Basic Configuration - HELICOPTER
Swash Plate Type
Enter the type of swash plate your helicopter is using. Refer to your
helicopter’s manual if necessary.
• „3 servos (default 120°)“ – the swash plate controls the
elevator, aileron and collective pitch functions by coodinating three
servos. In the swash plate configuration, the servo control points can
be shifted closer to or farther away from each other around the main
shaft axis in 1° increments to help eliminate any unwanted
swashplate movement. You will also use this setting if your heli
requires a swash plate configuration of 3 servos (140°) or 3 servos
(90°).
Within this menu you can also change the effective swash plate
servo „lever lengths“ to compensate for any nonlinear servo arm
travel.
· „ 4 servos (90°) - the swash plate controls the elevator, roll
and collective pitch functions by coodinating four servos in 90°
orientation. You can make the same changes to this type as with the
swash plate described above.