User Manual

computer radio control system

Each receiver channel can be configured to one of the modes

described above. We recommend that you setup „fail safe“ positions

for every output which enables your model to stay in a stable

condition. For instance, the elevator and rudder in neutral positions,

electric motor switched-off, gas engine idling, spoilers extended.

Receiver Type

Duplex R9 EX

3.3.

Configuration Method of the receiver failsafe function.

1. Bind receiver with transmitter. See chapter: 8.4 Binding. Leave

receiver and transmitter in switched-on condition.

2. In the transmitter, go to the menu „System->Jetibox“ and

proceed according to picture. Use the F1-F4 function buttons to

move within the menu.

3. In the „Set Output Pin“ menu select the receiver output which

you want to configure (use the left/right buttons) and proceed (by

using the down-button).

4. In the „Signak Fault Yn“ menu where n denotes the channel

number which has to be configured, use the right-button to edit the

output function showing a signal failure (set-up „fail safe“). You have

now activated the „fail safe“ function on receiver channel output n.

5. The „fail safe“ is adjusted by pressing the down-button and

changing to the „fail safe“ menu. With the left/right buttons edit the

„fail safe“ value in a range of 0,8ms to 2,2 ms. Adjust all of the

connected receiver outputs by repeating steps 3-5.

The last parameter to be set up is the elapsed time after signal failure

when the „fail safe“ or other actions after signal failure will be

initiated. In the „SignalFault Delay“ menu you can define the length

of time after a signal fault occurrs in which the preset throws are

applied. The values in this menu are changed by pressing the

left/right.buttons.