User Manual
Table Of Contents
- Manufacturer: Esprit Model
- DC-DS-16-EN-Part 1.pdf
- DC-DS-16-EN-Part 2.pdf
- Stránka 18
- Stránka 19
- Stránka 20
- Stránka 21
- Stránka 22
- Stránka 23
- Stránka 24
- Stránka 25
- Stránka 26
- Stránka 27
- Stránka 28
- Stránka 29
- Stránka 30
- Stránka 31
- Stránka 32
- Stránka 33
- Stránka 34
- Stránka 35
- Stránka 36
- Stránka 37
- Stránka 38
- Stránka 39
- Stránka 40
- Stránka 41
- Stránka 42
- Stránka 43
- Stránka 44
- Stránka 45
- Stránka 46
- Stránka 47
- Stránka 48
- Stránka 49
- Stránka 50
- Stránka 51
- Stránka 52
- Stránka 53
- Stránka 54
- Stránka 55
- Stránka 56
- Stránka 57
computer radio control system
EN
5. The„Functions Assignment“ menu lists
the flight functions and their control
switch/stick assignments. If you want to
change any of the switch/stick assign-
ments, select the „Control“ item for your
flight function and then select your desired
When you create a new helicopter model you are required to define
the swash plate configuration for the model. Please refer to your
helicopter’s instructions and verify that you have the correct swash
plate configuation. If you find that you need to change your swash
plate configuration you can always go to the „Model -> Basic
Properties“ menu to make the change.
6. The „Servo assignment“ menu displays
the receiver channels and their transmitter
output assignments. If you want to change
any of the output assignments, select the
channel you want to edit and reassign its
output. Otherways press „F5(Next)“ to
confirm.
7. The „Swash Mix“ menu displays the travel
range of each particular helicopter flight
function for the swash plate. The travel
range is displayed as a percentage. You can
use these these travel range adjustments to
prevent linkage binding and to tune the
8. The screen will display a question which
asks if you really want to create and activate
the new model. Press the „F5(Yes)“ button
to confirm.
9. The „Servo Setup“ menu is where you
can set all of your servo neutral positions,
servo output throw limits, servo reversing,
delay etc. You should return to this menu
after you have bound your receiver and
transmitter. See chapter 8.4: Receiver-
>Binding.
10. Once your transmitter has been bound with a receiver and has
been connected to its power supply, the last step consists of tuning
the servo output functions, see chapter 7.3.4: Setup of receiver
outputs.
In the „Fine tuning -> Flight modes“ menu you will setup these
advanced model control functions for your helicopter:
Collective pitch curve, see: Fine tuning -> Flight Modes->Function
Curves
Throttle curve, see: Fine tuning -> Flight Modes->Function Curves
Dual rates, see: Fine tuning -> Flight Modes -> Dual Rate/Expo
Autorotation, see: Fine tuning -> Flight Modes
Gyro/Governor see: Fine tuning -> flight modes -> Gyro/Governor
3.3.
helicopter to suit your flying style. (Refer to your helicopter’s
instruction manual.) Press the „F5(Next)“ button to confirm.
switch/stick for that flight function. Press „F5(Next)“ to confirm.