User Manual
Table Of Contents
- Manufacturer: Esprit Model
- DC-DS-16-EN-Part 1.pdf
- DC-DS-16-EN-Part 2.pdf
- Stránka 18
- Stránka 19
- Stránka 20
- Stránka 21
- Stránka 22
- Stránka 23
- Stránka 24
- Stránka 25
- Stránka 26
- Stránka 27
- Stránka 28
- Stránka 29
- Stránka 30
- Stránka 31
- Stránka 32
- Stránka 33
- Stránka 34
- Stránka 35
- Stránka 36
- Stránka 37
- Stránka 38
- Stránka 39
- Stránka 40
- Stránka 41
- Stránka 42
- Stránka 43
- Stránka 44
- Stránka 45
- Stránka 46
- Stránka 47
- Stránka 48
- Stránka 49
- Stránka 50
- Stránka 51
- Stránka 52
- Stránka 53
- Stránka 54
- Stránka 55
- Stránka 56
- Stránka 57
computer radio control system
EN
When setting up your spoilerons be sure that the ailerons still
have enough travel to control your airplane when the spoilerons
are deployed. In this menu the „(Sym) F1“ button will link or
unlink the spoilerons if you need to set them independantly.
Note:
7.3.2 Helicopter
Let’s create a simple model helicopter. In this example, the
helicopter is controlled by a swash plate with three servos at 120°
orientation and the motor has no governor.
Servo assignment for the receiver channels:
1. Throttle
2. Elevator (Swash 1F)
3. Collective (Swash 2L)
4. Aileron (Swash 3R)
5. Rudder (Yaw)
6. Gyro(Gyro sens.)
Before you begin creating a model make sure that you have set-up
the correct transmitter mode in „Main menu -> System ->
Configuration -> MODE 1-4“. The basic, standardized, assignment
of transmitter inputs to flight controls are based upon this selection.
First it is necessary to first create a model in the transmitter and then
bind the DC-16 transmitter with the receiver which will control the
given model. See chapter 8.4: Receiver->Binding.
For safety reasons we strongly recommend removing the
main/tail blades or disconnecting the motor when working
with an electric helicopter.
Notice:
1. Switch-on the transmitter. In the main
display push the key „menu“. Select the
item „Model“ and push the „3D button“.
2. Select the item „New model“ and push
the „3D button“.
3. Enter the name of your model and press
„F5(OK)“ (Note: you must enter a model
name to proceed.) Then select the model
type „Heli“. Confirm by pushing the
„F5(Next)“ button.
4. Select the helicopter swash plate type „3
servos (def 120°)“. Change the second
menu item „Position of front servo“ to
„Rear“ – the swash plate servo orientation
will be turned 180°. Confirm the change by
pressing the „F5(Next)” button.
3.3.