User Manual
Table Of Contents
- Manufacturer: Esprit Model
- DC-DS-16-EN-Part 1.pdf
- DC-DS-16-EN-Part 2.pdf
- Stránka 18
- Stránka 19
- Stránka 20
- Stránka 21
- Stránka 22
- Stránka 23
- Stránka 24
- Stránka 25
- Stránka 26
- Stránka 27
- Stránka 28
- Stránka 29
- Stránka 30
- Stránka 31
- Stránka 32
- Stránka 33
- Stránka 34
- Stránka 35
- Stránka 36
- Stránka 37
- Stránka 38
- Stránka 39
- Stránka 40
- Stránka 41
- Stránka 42
- Stránka 43
- Stránka 44
- Stránka 45
- Stránka 46
- Stránka 47
- Stránka 48
- Stránka 49
- Stránka 50
- Stránka 51
- Stránka 52
- Stránka 53
- Stránka 54
- Stránka 55
- Stránka 56
- Stránka 57
computer radio control system
EN
7.3 Model Set-up Guide
7.3.1 Airplane
Let’s create a simple model airplane. Our example will be a motor
glider with ailerons controlled by two servos, an elevator and a
rudder each controlled by one servo.
In this section we will guide you, step by step, through the process of
creating a new model airplane and helicopter. Each step of the guide
will be complete with associated transmitter menu photos. If you
follow the step by step guide you should become familiar with how
to create a model profile. You may even use these concepts and the
„General“ model type to create your own, user-defined model
profile.
Servo assignment:
1. Throttle
2. Aileron 1
3. Aileron 2
4. Elevator
5. Rudder
Before you begin creating a model make sure that you have set up
the correct transmitter mode in „Main menu -> System ->
Configuration -> MODE 1-4“. The basic, standardized, assignment of
transmitter inputs to flight controls are based upon this selection.
First it is necessary to first create a model in the transmitter and then
bind the DC-16 transmitter with the receiver which will control the
given model. See chapter 8.4: Receiver->Binding.
For safety reasons we recommend first removing the propeller.
Notice:
1. Switch-on the transmitter. In the main
display push the key „menu“. Select the
item „Model“ and push the „3D button“.
2. Select the item „New model“ and push
the „3D button“.
3. Enter the name of your model and press
„F5(OK)“ (Note: you must enter a model
name to proceed.) Then select the model
type „AERO“. Confirm by pushing the
„F5(Next)“ button.
4. Select your wing type. Because this
example has 2 aileron servos, select „Wing
type“ 0FLP/2WING. Do not change any
other setup items like tail assembly,
number of motors, number of spoilers or
number of landing gear servos. Continue
by pushing the „F5(Next)“ button.
3.3.