User Manual
Table Of Contents
- Manufacturer: Esprit Model
- DC-DS-16-EN-Part 1.pdf
- DC-DS-16-EN-Part 2.pdf
- Stránka 18
- Stránka 19
- Stránka 20
- Stránka 21
- Stránka 22
- Stránka 23
- Stránka 24
- Stránka 25
- Stránka 26
- Stránka 27
- Stránka 28
- Stránka 29
- Stránka 30
- Stránka 31
- Stránka 32
- Stránka 33
- Stránka 34
- Stránka 35
- Stránka 36
- Stránka 37
- Stránka 38
- Stránka 39
- Stránka 40
- Stránka 41
- Stránka 42
- Stránka 43
- Stránka 44
- Stránka 45
- Stránka 46
- Stránka 47
- Stránka 48
- Stránka 49
- Stránka 50
- Stránka 51
- Stránka 52
- Stránka 53
- Stránka 54
- Stránka 55
- Stránka 56
- Stránka 57
computer radio control system
EN
7.2. Navigation in the Menu
3.3.
To navigate within the transmitter menus, use the following
buttons:
1. The „menu“ button allows you to switch between the main
display and the transmitter‘s main menu. Also, If you push this
button while turning the 3D Control Selector to edit values, the
values can be changed faster. With the menu button pressed,
10 more values are changed per turn.
2. The „esc“ button allows you to move one level back within the
menu. If you push this button while you are editing a value you
will return one menu level and the edited value will NOT be
stored.
3. 3D Control Selector
3a - by turning the selector anticlockwise you will move up
in the menu. Turning the selector this direction will also
decrease any value you are editing.
- by turning the selector clockwise you will move down in 3b
the menu. Turning the selector this direction will also
increase any value you are editing.
by pressing the selector you will confirm your 3c
choice/enter the selected menu.
4. The „F1 - F5“ functions buttons located below the display are
used to select various options based upon the current display.
1
3
2
3b
3a
3c
7.2.1 Browsing through the Menu
The current selection within the menu (cursor) is designated by
reversed text/shaded graphics. By turning the 3D control selector
left/right you will move through the lines of a menu.
To select an item, first highlight the line and then press the „3D
button“, to select the line. Rotate the the 3D control selector to
highlight your selected item within the line then press the „3D
button“ to select the item. Rotate the 3D control selector either left
or right to change the value of your chosen item. By pressing the
„3D button“ again you will confirm the storage of your selected
value and go back to your previously selected menu item. If you
want to go back to select another line within the previous menu
press the „esc“ button.
Note: For each press of the „esc“ button, you are taken back one
menu level.
4