User Manual
Table Of Contents
- Manufacturer: Esprit Model
- DC-DS-16-EN-Part 1.pdf
- DC-DS-16-EN-Part 2.pdf
- Stránka 18
- Stránka 19
- Stránka 20
- Stránka 21
- Stránka 22
- Stránka 23
- Stránka 24
- Stránka 25
- Stránka 26
- Stránka 27
- Stránka 28
- Stránka 29
- Stránka 30
- Stránka 31
- Stránka 32
- Stránka 33
- Stránka 34
- Stránka 35
- Stránka 36
- Stránka 37
- Stránka 38
- Stránka 39
- Stránka 40
- Stránka 41
- Stránka 42
- Stránka 43
- Stránka 44
- Stránka 45
- Stránka 46
- Stránka 47
- Stránka 48
- Stránka 49
- Stránka 50
- Stránka 51
- Stránka 52
- Stránka 53
- Stránka 54
- Stránka 55
- Stránka 56
- Stránka 57
computer radio control system
EN
5 RF Transmitter Modules
In order to achieve the highest transmission quality and reliability of
the DC-16 transmitter, we have decided to equip the radio with two
independent DUPLEX 2,4GHz transmitter modules. The transmitter
modules have separate antennas. From the point of transmission
they are fully independent from each other. The RF modules of the
transmitter can operate in following modes:
• „Initial“mode – the primary transmitter RF module is active.
The secondary module can act as redundant unit. If the primary
module does not receive feedback from the receiver, the transmitter
can switch to the secondary transmitter RF module and
communicate with the receiver.
• „Dual“mode – the transmitter RF modules communicate
independently from each other with two different receivers. The
receivers can be interconnected via an intelligent synthesizer, for
instance the JETI Enlink, or the basic control functions can be divided
between two independent receivers. In this mode one part of a
model can be controlled with one receiver using the first transmitter
RF module, the other part of a model with a second receiver and the
second RF module. In an instant you have created a dual, redundant
flying system with two receivers and two RF modules.
• „Trainer“mode – the secondary RF transmitter module is
assigned to communicate with the instructor/student transmitter
only. Communication with the model takes place via instructor’s
transmitter only. If the DC-16 transmitter is in the „Instructor“ mode,
the primary RF module communicates with the model and the
secondary RF module communicates with the student’s transmitter.
If you are going to operate the DC-16 transmitter in France, your
transmitter should be setup for French transmitting mode „Main
menu -> System ->Configuration -> French mode -> Yes“
Note:
In the „Student“ mode the DC-16 transmitter communicates via the
secondary RF module with the instructor’s transmitter. If you operate
two of the DC-16 transmitters; one of them in the „Instructor“ mode
and the other one in the „Student“ mode, the transmitters
communicate between each other via the secondary RF transmitter
module. With this advanced system NO additional equipment is
necessary.
2.2.