User Manual

computer radio control system
EN
8
9
7
7
your direction (toward the transmitter back side).
6. Swap both stick unit assemblies and install them back into
correct positions.
7. Reinstall and secure the machine screws for each of the control
stick assemblies.
8. Connect control stick assembly wires to the Tx board connector
(3 wires X, Y, S ). Pay close attention to the wire lengths. Connect
the longest wire as the first one from the outside of the
transmitter (3 connectors X, Y, S).
9. Secure the stick assembly wires into their holders.
10. Reconnect transmitter battery pack and reinstall radio back
cover and cover screws.
After making a mode switch you must re-calibrate the
transmitter stick assemblies and set-up the correct
mode in the software menu, see section 9.6.1 –
Configuration. The switch between Modes 1 to 3 or
Modes 2 to 4 are done with the software only (NO
manual stick change is necessary).
Note:
4.3.6. Transmitter Gimbals with Switch or Button
Installation
If you want to operate the DC-16 transmitter using the optional stick
end switch or button functions, you must purchase one or more of
these separately:
• Stick with 2-position switch
• Stick with 3-position switch
• Stick with push-button
For installation of the optional gimbal stick ends with
switches/buttons we recommend that you send your
transmitter to one of the factory authorized service
centers or to your authorized dealer.
Advice:
1. Switch-off the transmitter and remove the 10 screws that secure
the radio back cover. Next, remove the radio back cover.
Be sure to disconnect the transmitter battery pack
connector.
2.
Disconnect the control stick assembly wires from the Tx board.
(3 wires X, Y, S)
3. Remove the stick assembly connecting wires from their holders.
2
3
4
4
X
Y
S
X
Y
S
2.2.