User Manual

5.
5.
computer radio control system EN




3. To edit the mix simply highlight the mix
and press the
“F4 (Edit)” button to go int o
the selected mix ’ s advanced menu .

a
b
c
d
e




a. F light mode setting c onfiguration
b. C ur v e type ic on
c.
S wit ch assig nment f or the spoiler mix func tion
d. Delay f or the mix function deployment or r etraction
e. Output travel settings
f or the individual ser v os



If your wing configuration has 4 flap surfaces and you only want the
outer flaps (the set furthest from the fuselage) to move with the
elevator with this mix then set the „Mix Output“ for columns „S2“
and
„S3“ to 0%. This setting will not allow the „S2“ or „S3“ flaps t o
move with the elevator mix function.
12.14 Flaps Mix – C amber C on tr ol

This is another popular sailplane mix. This mix allows you t o
effectively change the airfoil of your model‘s wing by combining the
flaps and ailerons to lower the trailing edge (under camber) of the
wing . T his helps to lower your flight speeds during landings or while
soaring . „Under camber“ is added to the wings when the flaps and
ailerons are deflected a little bit do wn war d . Adding under-camber
means that the bottom surface of the wing becomes more c onca v e .
T o use this mix your wing configuration must be „2A il“ or higher .
Y ou can either use a free mixer to set up this mix or you can use the
Butterfly mix.
Y ou can find the Butterfly menu in „Fine Tuning,
>Butterfly “ .

a
d

e
c


a. S wit ch assig nment f or butterfly mix func tion
b. Delay f or the mix function deployment or r etraction
c.
F light mode setting c onfiguration
d. Aileron servo travel settings
e.
F lap servo travel settings
f. Elevator servo travel setting