Operation Manual

EN
4
PRELIMINARY USE STAGES
Operation
Make sure that the domestic mains voltage is the same as that on the appliance rating plate. Place the
machine on a fl at surface.
Open the tank cover (7).
Fill the tank with tap water (max. 15° hardness) (Fig. 3).
NEVER fi ll the tank above the MAX level.
Plug the appliance into the mains socket, which must be earthed.
First Use
Before using the appliance for the fi rst time and also after a long period of non-use,
prepare several cups of water (without any coffee) to rinse the system through com-
pletely:
To rinse the Espresso and cappuccino maker
• Place one of the three fi lters in the fi lter holder (22)
• Tighten the fi lter holder on the left facing the external marking and turn it fi rmly to the right
• Place a large enough container under the fi lter holder.
• Turn steam control knob (12) to close position ‘●’
• Press “1cup/2cups” button on (I), then continue to press “ESPRESSO” button (L).
So the pump is then activated. If the boiler tank (water heating system) is empty (on fi rst use for
example) it will fi ll with water with a characteristic fi lling noise.
As soon as the water is running out of the fi lter holder, press “ESPRESSO” button (L) off.
• Allow the appliance to fi nish heating the water.
• Once the “ESPRESSO” light, (L) is off, press “ESPRESSO” button (L) again, allow 1 cup (green light)
water to run through button (I).
Repeat the action and pour the equivalent of two cups of water, pressing the button (I) (red light) and
three cups of water pressing the button (I) (blue light), interchanging the three fi lters every time.
Important!
After pouring coffee, wait at least ten seconds before disengaging the fi lter holder, turn it slowly to
from right to left, to prevent sprays or splashes of water or coffee.
Important!
Like on professional coffee machines, never remove the fi lter holder when the machine is opera-
ting; scalding hazard!
• Interrupt each time the process by pressing “ESPRESSO” button again.
To rinse the steam wand
• Place a container under the steam wand (13)
• Turn the steam control knob to ‘ ’ position
• As soon as the “ESPRESSO” light is off, slowly turn the steam control knob (12) to ‘MAX’ direction and
allow the steam to escape for about 10 seconds.
• Turn steam control knob (12) to close position’’●’
• Press “1cup/2cups” button (I) until the lit indicator switches off.
Important!
During the steam dispensing stage, never touch the surface of the steam wand, as they are very
hot. Danger of scalding.
It is also necessary to use containers in a material suitable for high temperatures (ceramic or
steel).