Operation Manual

PROGRAMMING PHASES

Auto start programming (Drip coffee automatic start time setting)

• Press the button “programming”(F) only once.

The icon (B) starts ﬂ ashing together with the time.

• Press the arrow buttons “ “ ” to set the time. (As the clock has a 12 hour display, every single

time the value 12 is reached, “AM” or “PM” are shown alternatively).

• Press the button “programming”(F) again.

The digits of minutes start ﬂ ashing.

• Press the arrow buttons “ “ ” to set the minutes.

The Auto start function is on and programmed to make coffee at the set time.

• Press the button “programming”(F) for the third time to enter the heating plate heat maintaining pro-

gramming.

Heating plate heat maintaining programming

The default duration of this function and the following automatic switching off is set in 2 hours from the

last dispensing cycle.

• The 1 digit value of the duration (in hours) of the function ﬂ ashes.

• Set the required hour number (from 1 to 5) by pressing the arrow buttons “ ” or “ ” several

times.

The function “Heating plate heat maintaining time programming” is set.

• Press the button “programming”(F) for the fourth time to enter the clock setting.

Clock setting

The icon (C) starts ﬂ ashing together with the time.

• Press the arrow buttons “ “ “ ” to set the time. (As the clock has a 12 hour display, every

single time the value 12 is reached, “AM” or “PM” are shown alternatively).

• By pressing the button “programming” (F) for the ﬁ fth time, the above described settings are stored.

Please Note: The ﬂ ashing of “:” between hours and minutes shows that the clock is working

properly and the exit from the programming mode.