Data Sheet
Table Of Contents
- 1 Module Overview
- 2 Block Diagram
- 3 Pin Definitions
- 4 Electrical Characteristics
- 5 Module Schematics
- 6 Peripheral Schematics
- 7 Physical Dimensions and PCB Land Pattern
- 8 Product Handling
- 9 U.S. FCC Statement
- 10 Related Documentation and Resources
- Revision History
9 U.S. FCC Statement
9 U.S. FCC Statement
Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v01:
1. List of applicable FCC rules
FCC Part 15 Subpart C 15.247 & 15.209
2. Specific operational use conditions
The module is a module with WiFi and BR,EDR,BLE function.
• Operation Frequency: WiFi 2412 ~2462 MHz;BT: 2402 ~ 2480 MHz
• Number of Channel:WiFi:12 ;BT: 40
• Modulation:WiFi:DSSS/OFDM ;BT:GFSK/�/4-DQPSK/8DPSK
• Type: PCB Antenna
• Gain: 3.96 dBi Max.
The module can be used for IoT applications with a maximum 3.96 dBi antenna. The host manufacturer
installing this module into their product must ensure that the final composit product complies with the FCC
requirements by a technical assessment or evaluation to the FCC rules, including the transmitter operation.
The host manufacturer has to be aware not to provide information to the end user regarding how to install
or remove this RF module in the user’s manual of the end product which integrates this module. The end
user manual shall include all required regulatory information/warning as show in this manual.
3. Limited module procedures
Not applicable. The module is a single module and complies with the requirement of FCC Part 15.212.
4. Trace antenna designs
Not applicable. The module has its own antenna, and does not need a host’s printed board microstrip
trace antenna, etc.
5. RF exposure considerations
The module must be installed in the host equipment such that at least 20cm is maintained between the
antenna and users’ body; and if RF exposure statement or module layout is changed, then the host
product manufacturer required to take responsibility of the module through a change in FCC ID or new
application. The FCC ID of the module cannot be used on the final product. In these circumstances, the
host manufacturer will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
6. Antennas
Antenna Specification are as follows:
• Type: PCB Antenna
• Gain: 3.96 dBi
• Type: Ipex Antenna
• Gain: 2.33 dBi
This device is intended only for host manufacturers under the following conditions:
• The transmitter module may not be co-located with any other transmitter or antenna.
Espressif Systems 29
Submit Documentation Feedback
ESP32-PICO-MINI-02 & PICO-MINI-02U Datasheet v1.0