Data Sheet

8 Product Handling
8 Product Handling
8.1 Storage Conditions
The products sealed in moisture barrier bags (MBB) should be stored in a non-condensing atmospheric environ-
ment of < 40 °C and /90%RH. The module is rated at the moisture sensitivity level (MSL) of 3.
After unpacking, the module must be soldered within 168 hours with the factory conditions 25±5 °C and /60%RH.
If the above conditions are not met, the module needs to be baked.
8.2 Electrostatic Discharge (ESD)
• Human body model (HBM): 2000 V
• Charged-device model (CDM): 500 V
• Air discharge: 6000 V
• Contact discharge: 4000 V
8.3 Reflow Profile
Solder the module in a single reflow.
50
150
0
25
1 ~ 3 ℃/s
0
200
250
200
–1 ~ –5 ℃/s
Cooling zone
100
217
50
100 250
Reflow zone
217 ℃ 60 ~ 90 s
Temperature (℃)
Preheating zone
150 ~ 200 ℃ 60 ~ 120 s
Ramp-up zone
Peak Temp.
235 ~ 250 ℃
Soldering time
> 30 s
Time (sec.)
Ramp-up zone — Temp.: 25 ~ 150 ℃ Time: 60 ~ 90 s Ramp-up rate: 1 ~ 3 ℃/s
Preheating zone — Temp.: 150 ~ 200 ℃ Time: 60 ~ 120 s
Reflow zone — Temp.: >217 ℃ 60 ~ 90 s; Peak Temp.: 235 ~ 250 ℃ Time: 30 ~ 70 s
Cooling zone — Peak Temp. ~ 180 ℃ Ramp-down rate: –1 ~ –5 ℃/s
Solder — Sn-Ag-Cu (SAC305) lead-free solder alloy
Figure 8: Reflow Profile
Espressif Systems 27 ESP32-MINI-1U Datasheet v0.5