User's Manual

!
5. Build and Flash
5. Build and Flash
5.1. Build and Flash
Now you can build and flash the application. Run:
make󰲧flash
This will compile the application and all the ESP-IDF components, generate bootloader,
partition table, and application binaries, and flash these binaries to your ESP32 board.
esptool.py󰲧v2.0-beta2
Flashing󰲧binaries󰲧to󰲧serial󰲧port󰲧/dev/ttyUSB0󰲧(app󰲧at󰲧offset󰲧0x10000)...
esptool.py󰲧v2.0-beta2
Connecting........___
Uploading󰲧stub...
Running󰲧stub...
Stub󰲧running...
Changing󰲧baud󰲧rate󰲧to󰲧921600
Changed.
Attaching󰲧SPI󰲧flash...
Configuring󰲧flash󰲧size...
Auto-detected󰲧Flash󰲧size:󰲧4MB
Flash󰲧params󰲧set󰲧to󰲧0x0220
Compressed󰲧11616󰲧bytes󰲧to󰲧6695...
Wrote󰲧11616󰲧bytes󰲧(6695󰲧compressed)󰲧at󰲧0x00001000󰲧in󰲧0.1󰲧seconds󰲧(effective󰲧920.5󰲧kbit/s)...
Hash󰲧of󰲧data󰲧verified.
Compressed󰲧408096󰲧bytes󰲧to󰲧171625...
Wrote󰲧408096󰲧bytes󰲧(171625󰲧compressed)󰲧at󰲧0x00010000󰲧in󰲧3.9󰲧seconds󰲧(effective󰲧847.3󰲧kbit/
s)...
Hash󰲧of󰲧data󰲧verified.
Compressed󰲧3072󰲧bytes󰲧to󰲧82...
Wrote󰲧3072󰲧bytes󰲧(82󰲧compressed)󰲧at󰲧0x00008000󰲧in󰲧0.0󰲧seconds󰲧(effective󰲧8297.4󰲧kbit/s)...
Hash󰲧of󰲧data󰲧verified.
Leaving...
Hard󰲧resetting...
Espressif
! /126
2017.05