User's Manual

Any changes or modiﬁcations not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operaion.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance

20cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter.

Disclaimer and Copyright Notice

Information in this document, including URL references, is subject to change without

notice.

THIS DOCUMENT IS PROVIDED AS IS WITH NO WARRANTIES WHATSOEVER,

INCLUDING ANY WARRANTY OF MERCHANTABILITY, NON-INFRINGEMENT, FITNESS

FOR ANY PARTICULAR PURPOSE, OR ANY WARRANTY OTHERWISE ARISING OUT

OF ANY PROPOSAL, SPECIFICATION OR SAMPLE.

All liability, including liability for infringement of any proprietary rights, relating to use of

information in this document is disclaimed. No licenses express or implied, by estoppel or

otherwise, to any intellectual property rights are granted herein.

The Wi-Fi Alliance Member logo is a trademark of the Wi-Fi Alliance. The Bluetooth logo is

a registered trademark of Bluetooth SIG.

All trade names, trademarks and registered trademarks mentioned in this document are

property of their respective owners, and are hereby acknowledged.

Espressif IOT Team"

www.espressif.com

FCC Warning:

Espressif

12/12

2017.05

FCC Label Instructions:

If using a permanently affixed label, the modular transmitter must be labeled with its own

FCC identification number, and, if the FCC identification number is not visible when the

module is installed inside another device, then the outside of the device into which the module

is installed must also display a label referring to the enclosed module. This exterior label

can use wording such as the following:

“Contains Transmitter Module FCC ID: 2AC7Z-ESP32WROVER, or

“Contains FCC ID: 2AC7Z-ESP32WROVER

Any similar wording that expresses the same meaning may be used. The Grantee may

either provide such a label, an example of which must be included in the application for

equipment authorization, or, must provide adequate instructions along with the module which

explain this requirement.