Repair manual

4
1 / Introduction
Liability claims / warranty
Adherence to the official regulations and the safety instructions
is essential if any liability claims are to be accepted.
Failure to observe the official regulations and the safety
instructions will result in exemption of the heater manufacturer
from liability.
Accident prevention
The general Accident Prevention Regulations and the
corresponding plant and operational protective instructions
must be observed.
Special notation, pictures and pictograms
This document uses special notation and pictograms to give
emphasis to different types of information.
Their meaning and how you should respond to them are
explained in the examples below.
Special notation and pictures
A bullet symbol (•) is used to indicate a list which is introduced
by a heading.
If an indented dash (-) occurs after a bullet point, then this list
is subordinate to the main bullet list.
Pictograms
Regulation
This pictogram, accompanied by the caption “Regulation”,
indicates a statutory requirement.
Failure to comply with this regulation will cause the
General Type Approval for the HYDRONIC to lapse and
invalidate the warranty and any liability on the part of
J. Eberspächer GmbH & Co.
Danger!
This pictogram, accompanied by the caption ”Danger”, draws
your attention to an imminent danger to life and limb. Failure to
observe this instruction could result in serious injury.
Important!
This pictogram, accompanied by the caption “Important!”,
draws your attention to a situation which is potentially
dangerous to a person and / or the product.
Failure to observe this instruction could result in physical injury
and / or damage to the equipment.
Please note!
This instruction provides recommendations for use and helpful
tips regarding the installation and / or repair of the HYDRONIC.