Repair manual

Removing the hood (see Drawing 24)

• Undo the two fixing screws on the hood.

• Take off the hood.

Beware danger of injury!

• The fan wheel has sharp edges.

- Avoid contact with the fan wheel and, if

necessary, wear protective gloves.

~ Fixing screw

Figure 1

Figure 2

5 / Repair Instructions

Removing the burner (see Figure 1).

• Take off the hood.

• Pull out “Temperature sensor” and “Safety thermal cutout

sensor” cable sections on the control unit.

• Take grommet out of burner casing.

Please note!

The fuel lines should remain connected. If necessary, lengthen

the fuel lines.

~ Burner

Ä Heat exchanger

Å Grommet

Ç “Temperature sensor” and “Safety thermal cutout sensor”

cable sections

Remove control unit (see Figure 2)

• Take off the hood.

• Remove burner.

• Unscrew the fan wheel in an anti-clockwise direction,

counter-restraining the motor shaft with screwdriver.

• Pull off connectors on the front and rear sides of the control

unit.

• Unlock and remove control unit with the 4 clamps.

~ Control unit

Ä Clamps

Å Motor shaft (threaded)

Drawing 24