User`s guide

Setup Software
Sting II User Guide 36
Updating the STING II
Occasionally, the STING II software is updated. These updates are available
without charge by connecting the STING II and downloading the new
version. There are several options for upgrading.
To upgrade the STING II firmware:
1. Download the file from the Internet and save the file to the STING
II’s memory card.
2. Insert the memory card into the STING II, while the STING II is
turned Off.
When you turn the STING II On, the red and green lights will flash,
indicating that the unit is in the process of being updated. This process will
take about three minutes and it is important not to interrupt the STING II
while it is the process of upgrading. When the LEDs stop flashing, the top
light should be green, indicating a successful upgrade.
If the second light is red, or any other color but green, this may indicate
that you are low on disk space and may need to delete some or all of the
files before starting another recording session. If both lights are green, you
are ready to use the STING II with the latest available software.
Note: After upgrading the software, it is recommended
that you click Factory Defaults on the Systems
tab.
You are asked to confirm your selection. Click OK to reset the settings to
the factory defaults, or Cancel to close the dialog box without changing the
current configuration.