User`s guide

Recording Sessions
Sting II User Guide 12
• Pressing the button on the Vibrating Remote briefly (for less than 5
seconds).
Recording Methods
Once you determine the type of file you wish to record and configure these
settings in the Setup, you only have to start and stop recording sessions
using the STING II. There are several ways to start and stop recording
sessions. These include:
• Via Vibrating Remote
• Via Infrard Remote Control
• Via the STING II unit’s control panel
• Via Motion Sensor
Via Vibrating Remote
STING II comes with a vibrating remote device that enables you to quickly
start and stop recording by simply pressing a button. The remote control is
composed of a push-button and a cable connected to a vibrating motor. It
can be used for:
• Starting and stopping the recording.
• Getting indications, by vibration, for low battery, low memory, a
disconnected video cable and any other malfunction.
The STING II unit can be concealed completely, leaving only the camera
and vibrating remote accessible to start and stop the recording session.
To start recording with the vibrating remote:
Press the button on the vibrating remote cable and hold it for 5 seconds
until the remote control begins to vibrate. The remote will vibrate for a few
seconds as an indication that the STING II is now recording. If you are
viewing the STING II, you will also notice a blinking red light on the top of
the device as a further indication that the device is recording.
To stop recording with the vibrating remote:
Press the button again and hold it for 5 seconds until it starts to vibrate.
The remote will vibrate in three short pulses, indicating that the recording
is off.
While the vibrating remote is attached to the STING II, all
buttons on the STING II are not operational. This
prevents you from accidentally starting or stopping a
recording session accidentally. Only the button on the
vibrating remote can start or stop a session while the
cable is plugged into the STING II.
To take a still picture (a single .jpg file), press the vibrating remote button
and release immediately. Each time you press the vibrating remote button
for less than 2 seconds, another snapshot image will be taken by the
camera and stored for later viewing.