Instruction Manual

www.espuk.com

Month Test

Sign Date Sign Date Sign Date Sign Date Sign Date

1 Functional

2 Functional

3 Functional

4 Functional

5 Functional

6 1 hour

7 Functional

8 Functional

9 Functional

10 Functional

11 Functional

12 3 Hour

1st year 2nd Year 3rd Year 4th Year 5th year

Luminaire Type/Ref: Date of Installation: Location:

TEST RECORD SHEET

Rated input supply: AC 240V 50Hz

Rated output power: 8 x SMD 2835 LED

Operating Environmental: Temperature:- 0-40°C

Operating relative humidity: Less than 90%

Emergency Duration: More than 3 Hours.

Change over time: Less than 1 second.

EMDLED3WMBULK2

3W LED IP65 Maintained Emergency Bulkhead

GENERAL INFORMATION

Our products are designed to comply with the recommended codes of practice

for emergency lighting of premises and be installed by competent person in

accordance with the relevant wiring regulations.

LUMINAIRE INFORMATION

Battery Specification: 3.6v 1200mAh NI-CAD Batteries

MONITORING

Green indicator lamp (LED) normally continuously ‘on’. Indicator lamp goes

out if A.C. supply or charger fails.

For additional product information please visit the ESP website

www.espuk.com/technical_support/product_manuals/?cat=5

G20

IP65

PAGE 1
Functional Functional Test 2 Functional Month 3 Functional Functional 7 Functional 4 8 Functional Functional 9 Functional 5 10 Functional 1 hour 11 3 Hour 6 12 LuminaireType/Ref: www.espuk.
PAGE 2
WARNING • This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing. Irreparable damage will occur if this instruction is not followed • Recommended routine test procedure in accordance with BS 5266 • Daily check - check that the status GREEN LED indicator is illuminated • Monthly functional test - simulate a mains supply failure for approx. 30 secs by operation of a key switch or circuit breaker.