Specifications

18
This option enables turning the power
to the specimen ON or OFF with
contact signal output when the time is
up by using the timer function on the
controller.
Power supply rating: 250VAC 1A
Actuation: Contact close when
program time overflows
Where located: Right side of chamber
Automatically starts and stops chamber
operation.
Setting range:
Sunday to Saturday
(Possible to set multiple days)
0:00 to 23:59
(Setting resolution 1 minute)
Margin of error per month:
±
1 minute
Automatically opens or closes
synchronously with program operation
for ventilation and faster cooling of
chamber temperature.
Displays cumulative chamber operation
time.
Available with or without reset feature.
* Operating time is not accumulated when
operation is stopped due to malfunction or for
other reasons.
Measuring time: 999,999 hr
Outputs chamber temperature through
thermocouple type K (JIS C 1602)
(Thermocouple type N for STPH, SSPH)
Where located:
Rear of electrical compartment
OPTIONS
Automatic damper
Integrating hour meter
Temperature recorder terminal
Calendar timer
Time run-out output
●Please refer to chart on p.17 for applicable models.
Temp. range: 0 to
＋
200
℃
0 to
＋
300
℃
0 to
＋
600
℃
0 to
＋
800
℃
Recording system:
Pen recorder (1 pen)
or multi-point recorder (6 dots)
* If performing simultaneous installation of a
recorder and an N
2
gas injector, they must be
handled individually. Otherwise, installation
may be limited depending on what other
options are chosen.
Temperature recorder
Records temperature of each section
such as the temperature inside the
chamber.
Temp. range: 0
〜＋
200
℃
0
〜＋
300
℃
0
〜＋
600
℃
0
〜＋
800
℃
Number of inputs: Temperture 1
(5 more channels can be turned ON)
Data saving cycle: 5 sec
External recording media:
CF memory card port
(Includes a 256MB CFcard)
Language support: ENG, JPN
Paperless recorder
Preparation of a power cable, tempera-
ture sensor and a grounding wire for
additional installation in the future.
Temperature recorder wiring