Specifications

OPTIONS
Test area low-silicone
Brake oil protection
Reduces the production of silicone gas
(siloxane) in the test area.
Changes resin parts (water tank f ront
cover, door dew tray, chamber dew tray) to
stainless steel.
Stainless steel evaporator
Changes the plate fin cooler (also used as a
dehumidif ier) to stainless steel, which
improves the corrosion resistance.
* Standard performance may not be met
under certain conditions. Inquire for
details.
Finned sheathed heater
Changes the heater to a sheathed heater with
fins to lower the surface temperature of the
heater, decrease corrosion, and reduce
defective insulation.
Operation manual
Reports & certificates
• DVD
• Booklet
• Calibration results
• Traceability system chart
• Traceability certificate
• Testing and inspection report
• Test data
• Temperature (& humidity)
uniformity measurement
Air circulator removed for move-in
To prevent da mage caus ed by height
restrictions, the air circulator for type 4
chambers is not mounted on the chamber
during shipment.
* The air circulator must be installed
separately.
Safety precautions
● Do not use specimens which are explosive or inflammable, or which contain such
substances. To do so could be hazardous, as this may lead to fire or explosion.
● Do not place corrosive substances in the chamber. If corrosive substances are
generated by the specimen, the life of the chamber may be significantly shortened
specifically because of the corrosion of stainless steel and copper and because of
the deterioration of resin and silicon. An optional corrosion-resistant cooler, which
is designed to improve the corrosion resistance of the chamber, is available.
● Do not place life forms or substances that exceed allowable heat generation.
● Be sure to read the operation manual before operation.
38