Manualshelf

User guide

ManualsBrandsESP ManualsComputer equipmentDigiview4i
21222324252627282930
MOTION DETECTION
CHANNEL-1 SENSITIV 0 (OFF)
AREA SETUP
CHANNEL-2 SENSITIV 1
AREA SETUP
CHANNEL-3 SENSITIV 5
AREA SETUP
CHANNEL-4 SENSITIV 2
AREA SETUP
PRESS (<,>) THEN (SELECT)
PRESS (MENU) TO EXIT
MOTION SET UP
SENSITIVITY: Sets the sensitivity level for
Motion Detection. 0 (OFF) to 5 (maximum sensitivity).
▼ and ▲ buttons to select the sensitivity for
each Channel
button to select the level.
AREA SETUP: Used to define up to two zones per Channel where motion is to be
detected.
Selecting a “Channel Area Set Up” brings that Channel up full screen on the monitor.
A rectangle is displayed, which will define the top left hand corner as the first motion
detection zone. Use ▼ and ▲ buttons to move the rectangle up and down and and
buttons to move the rectangle left and right. Use button to set the position and start to
set up the motion detection territory. Then use
▼, ▲,, and to define the territory.
Press button for the second motion detection zone and repeat the procedure above to
define its motion detection
MOTION SETUP MENU