Full Product Manual

11
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
ENGLISH
Operator's Manual
Propane Powered Ice Auger
Contact service provider if above remedies fail, or visit our website at www.GetEskimo.com for additional frequently asked questions.
ORDERING REPAIR PARTS
Parts may be obtained from the store where your auger was purchased or by calling Ardisam customer service at the number listed
below. To order from the factory, call, e-mail, or order online at www.GetEskimo.com:
Eskimo®
A Division of Ardisam, Inc.
1-800-345-6007
E-mail: [e-mail]
Please include the part numbers, part description, quantity, model number, and serial number.
PROBLEM POSSIBLE CAUSE REMEDY/ACTION
Engine will not start 1. On/O valve o 1. Switch to ON
2. Spark plug wire disconnected 2. Connect spark plug wire to spark plug
3. Out of fuel 3. Refuel
4. Spark plug wet, faulty or
improperly gapped
4. Clean, replace or gap spark plug
Engine runs rough, oods during
operation
1. Dirty air lter 1. Clean or replace air lter
2. Carburetor out of adjustment 2. Consult authorized service center
Engine is hard to start 1. Excessive oil in cylinder 1. Remove spark plug and clear oil from plug and
cylinder
2. Fuel too cold 2. Replace cylinder with one that has been stored in a
warm location
3. Engine too cold 3. Move engine to a warm location to warm up
Engine misses or lacks power 1. Faulty ignition coil 1. Take to authorized service center
2. Carburetor out of adjustment 2. Take to authorized service center
Auger turns at idle 1. Idle speed too high 1. Adjust idle speed lower
2. Broken clutch spring 2. Replace both springs
Auger turns, but has no power 1. Carburetor out of adjustment 1. Consult authorized service center
2. Broken transmission 2. Consult authorized service center
3. Worn clutch shoes 3. Replace clutch shoes and springs
Auger jumps on ice 1. Blades damaged or sharpened
incorrectly
1. Replace with new blades
Auger cuts slowly 1. Dull blades 1. Replace with new blades
2. Damaged point 2. Replace with new point
TROUBLESHOOTING AND REPAIR