Specifications

ESI

1-8/9-16 Button

NeONsupports16controlpotsand16faders,eventhoughonly8ofeacharelocatedonthefrontpanel.

Toswitchbanks,pressthe1‐8/9‐16button.Whenin1‐8mode,theLEDinthebuttonwillbeoff,whenin

9‐16modeitwillbeon.



Data Entry Wheel Assignment

The Data Wheel can be assigned either using the Ctrl Assign procedure as described above or the

following:

1. PresstheSHIFT+DataEntryAssignbutton.TheLEDwilllight.

2. Next,movetheDataWheel.ThenumberofthecontrollerwillbedisplayedontheLEDdisplay.

3. Type

intheMIDIcontrollernumberyouwishtoassigntothecontroller.

4. PressENTERtocompletetheprocess.

5. AssigningaMIDIchanneltotheDataWheelisthesameasdescribedabove.

Program Store and Recall

NeON can save up to 16 configurations in internal memory. All controllers, MIDI channel, and other

settingsaresavedinnon‐volatilememory.Patch 0 is default andisloadedatpower‐up. Thiscannotbe

changedbytheuser,but1‐16arefullyprogrammable.Tosaveapatch:

PressSHIFT+Save

2. Typeinthelocationyouwithtosavethecurrentconfigurationin(1‐16)

3. PressENTER

REMEMBER:Savingapatchpermanentlyoverwritesthepreviouslystoredconfiguration!!!

RecallingapatchisthesameasStoring,exceptpressSHIFT+RECALL.

Panic

If a MIDI system is “hung”, Panic button will send MIDI note‐off messages to every note on every

channeltorestoreordertothesystem.