Installation manual

IVX C-Class with voice mail: Installation Manual Function 5: Voice mail programming
H.3
Function 551: Station delivery options
Programming of the station options, as shown below, can be performed by the Installer or
Administrator. In addition, the user can change his phone number and pager number (but not phone
or pager delay time). The phone number’s maximum length is 24 digits.
1.
Number
2.
Delay
3.
Attempts
4.
Interval
5.
Quiet on
6.
Quiet off
1. Phone [phone] 10:30PM 7:15AM
2. Pager 9725551234 0 10 30
To program, enter the station/extension number and choose 1 for phone number or 2 for pager
number. Then, follow the prompts to set the parameters below.
1. Phone/pager number — The number to be dialed (without the CO line Group [9, 8 or 7).
2. Delay — How many minutes the system is to wait before dialing the phone or pager number.
This allows the user to pick up a message if he is in the office.
Range: 0–500. Default: 0.
3. Attempts — How many times the system will call/page.
Range: 0–99. (0 turns off delivery.) Default: 3.
4. Interval — How many minutes should elapse between attempts.
Range: 10–1440. Default: 30.
5. Quiet period on — When the quiet period should begin.
Default: (None.)
6. Quiet period off — When the quiet period should end.
Default: (None.)
Code What it produces
# # DTMF tone


DTMF tone
F Flash hook
P 2-second pause
To insert a special code, press the right scroll key (

) to select the desired special code: # ,

,
F or P. Press # to confirm the inserted character and continue. Press # # to complete the entry.
Use the left scroll key (

) to backspace.
Once the number is saved you can use the scroll keys to move back and forth to view the
number. To edit the number, you must delete it and enter the correct number.
Function 552: Delivery/paging parameters
The sequence of programming is as follows:
1. CO line access — Enter the CO line group (9, 8, or 7) that is to be accessed for delivery.
Default: 9.
2. Maximum lines — Enter the maximum number of lines (in the selected CO line group) that the
system can access simultaneously. Make enough lines available to accommodate high
notification traffic (but be careful: if you make available all lines in the selected line group and
high notification traffic occurs, the system could tie up all lines).
Range: 1–19. Default: 1.
3. Pager dialing pause — When paging, the IVX 20c will send the mailbox number to be shown in
the pager’s display. To allow time for the paging service to answer, enter the pause, in seconds,
to occur between when the IVX 20c dials the pager number and when it then dials the mailbox
number.
Range: 0–20. Default: 6.