Installation manual

IVX C-Class with voice mail: Installation Manual Function 1: System parameters
D.1
Function 1: System parameters
Function 11: Initialize
This function will return all components and software to their initial state. Initialization will erase all data
and custom recordings.
Important: Always initialize the system before initial programming for a new installation.
You must confirm the command to initialize, when prompted, by entering the Installer password.
Be sure to set the time and date (Function 14) before initializing.
System initialization will take approximately one minute to complete. When initialization is completed,
the phone’s display will return to the idle state. You must then re-access programming mode by
following the steps described earlier (see page C.3).
Functions 12 and 13: Installer and Administrator passwords
These functions will display the existing password and prompt for entry of a new password. The passwords
can be 2–8 digits long, followed by #. The Installer can change either the Installer or Administrator
Password. Only those functions listed in the Administrator’s Manual can be programmed via the
Administrator password. The default passwords are:
Installer password (Function 12) = 7 8 9
Administrator password (Function 13) = 4 5 6
Notes: Be sure to write down the new passwords, store them in a safe place and give the new Administrator’s
password to the Administrator.
Accessing user station programming
Should a user forget his password or if an employee leaves the organization, this feature allows the
Installer or Administrator to enter a user's station programming and operate within it as if he were the
user. From the user’s station, enter the Installer or Administrator password when the system prompts
for the user password.
Example: From station 105, entering 7 8 9 # or 4 5 6 # instead of the user password (1 0 5 #) will enter the
station’s user programming. (Default passwords shown for this example).