Installation manual

IVX C-Class with voice mail: Installation Manual System programming: An introduction
C.3
System programming overview: Programming menu
1 System parameters
11 Initialize
12 Installer password
13 Administrator password
14 System clock
141 Set time/date
142 Automatic time setting
15 System timing parameters
151 Flash duration
152 Transfer forward timer
153 Recall timers
16 System feature parameters
161 Recording alert tone
162 Connect tone
163 Station feature set activation (Generation II only)
165 Auto attendant parameters
166 CO parameters
167 Voice mail parameters
17 System speed-dial
18 Maintenance/SMDR serial port baud rate
2 CO line programming
21 Line programming
22 Translation table programming
221 Centrex/PBX access code
222 Toll restriction exception tables
23 Line parameters
231 Line receive volume
232 Analog line disconnect
24 Caller ID programming
3 Extension programming
31 Extension definition and routing
32 Extension feature authorization
33 Department programming
35 Extension button mapping
4 Auto attendant programming
41 Auto attendant branch programming
42 Announce extension number
43 Automatic day/night mode table
5 Voice mail programming
53 Guest/info mailboxes
55 Message notification options
56 Cascade paging mailboxes
6 Recording
61 Record system prompts
62 Record directory names
63 MOH programming
631 MOH source
632 Record MOH
633 MOH volume
Accessing programming
You may program from any 24-Key Digital Feature Phone in the system:
1. Press PROG/HELP.
The normal station programming menu prompt will begin to play. Press HOLD to stop the prompt.
2. Enter the Installer password followed by # (the default password is 789). You are now in
programming mode (during this time, the extension will be automatically placed in DND).
3. Follow the system programming menu to program as you wish; and, when finished, hang up.
Note: The system will automatically exit programming mode after 10 minutes of inactivity.
Example: If your Installer password is 864, enter programming mode by pressing PROG/HELP HOLD 8 6 4
#. (To exit programming mode, hang up.)