Installation manual

Function 3: Extension programming IVX C-Class Installation Manual
F.4
Function 32: Extension feature authorization
The Installer or Administrator can allow or deny many extension features on an extension-by-extension
basis. A user, however, can only program and use allowed features (by using a combination of voice
and display prompts) from his/her phone.
Below is an example of a completed programming worksheet. The programming sequence is:
1.
Ext.
2.
Name
3.
Toll allow
4.
System speed- dial
5.
Trunk-to-trunk
XXX Default Y Y N
100 Jane Y Y N
101 Roger Y Y N
102 Sally Y Y N
124 Bill Y Y N
The programming steps are:
1. Extension number — Enter the extension number to program.
2. Extension name — Name the extension (if not previously named in Function 31 [see page F.1]).
For each of the following features, press a scroll key ( or ) to select YES or NO.
3. Toll restriction — “YES” allows the user to place toll calls. If you select “NO,” the user can make
only either non-toll calls or calls to numbers listed in the allow exception table.
4. System speed dial — “YES” allows the user to access and place system speed dial calls.
5. Trunk-to-trunk — If enabled, this feature allows manual trunk-to-trunk transfers. While connected
to an outside call, the user can press TRANSFER, dial an offsite number and then complete the
trunk-to-trunk transfer by simply hanging up. Both outside parties are then connected.