Installation manual

IVX C-Class Installation Manual Function 3: Extension programming
F.1
Function 3: Extension programming
This section provides programming for extensions and department groups.
Important: Where any gray shading (■) appears in an example, it represents values either unavailable to
the function or unused in the particular example.
Function 31: Extension definition and routing
Extensions can be either:
• Digital Feature Phone extensions (DIGITAL in the chart below and succeeding charts)
• Analog ports (PHONE, FAX, MODEM, RINGER or DOOR in the same charts)
Digital extensions may be 100–111; analog extensions are 112 or 113.
Digital Feature Phones
Here’s an example of the portion of a completed programming worksheet for Digital Feature Phones.
1. 2. 3. 4. 5. 6. 7. 8.
Ext. Type Name CO CF day CF night Page zone Ext.
0 Operator X100, X101 X100, X101 X100
100 DIGITAL Jane 9 0
101 DIGITAL Roger 9 0
102 DIGITAL Sally 9,8 0
112 EXT Roger 2 9 0
113 FAX FAX
Note: 100 defaults as OPR (when a user dials 0).
Each programming step for Digital Feature Phone extensions is defined as follows:
1. Extension number — Extension numbers range from 100 to the highest number of ports
installed and must match the port numbers as connected to the system.
2. Type — Based on the port card installed, IVX C-Class assigns the port as digital.
1
3. Extension name — Used for the display, reports, and as a programming aid. The name’s
length can be no longer than 10 characters (See “Entering alphanumeric characters,” page C.2).
Default: The extension number.
4. CO line group — Assigns the extension’s ability to access one or more CO line groups (9, 8,
and 7).
Default: 9.
5. Call forward busy/no answer for day mode — Operator calls are set to forward busy/no-
answer calls to another extension for day mode.
Default: 0 (no forwarding).
6. Call forward busy/no answer for night mode — Same as previous item, except night mode.
(Continued)
1
For programming of analog ports, see page F.2.