User`s guide

User’s Guide ESI Feature Phone operation
D.5
To call another station programmed into one of your station keys:
1. Press an available (unlit) station key.
2. The called station will sound a short ring followed by a double connect tone.
3. The phone system will activate the called station’s speakerphone (or the station will ring if that
station’s user has hands-free answer disabled).
4. To disconnect when finished, do one of the following:
(a.) Replace the handset.
or
(b.) (if in hands-free mode) Press the station key again.
or
(c.) Press SPEAKER (if in hands-free mode).
If you press a key for a station that’s in use (red; steadily lit), you will “camp onto” the station, where its
Feature Phone’s display will tell its user that you’re waiting (see “Call waiting,” page D.7).
If you press a key for a station that’s in DND (amber; steadily lit), you’ll be forwarded directly to the
person’s mailbox.
Transferring an outside call to another station
Blind transfer
1. While connected to an outside call, press a station key (or press TRANSFER and then dial the
extension number).
2. Hang up immediately to perform a blind transfer.
Note: If the called person does not answer, the caller will be disconnected after four minutes.
Supervised transfer — announcing the caller to the called person
1. Do not hang up (as in “Blind transfer,” above); instead, wait until the called person answers.
2. Announce the caller (e. g., “Hello; I have Bill on the line and I’m transferring him to you now.”)
3. Hang up.
Note: If the transferred-to person does not answer in step 1, press the station key again or press FLASH
to be reconnected to the original caller.