Specifications

ESP1010

- 29 -

11. Specifications

1. Analog Inputs

1) Connector Type: 1/4" female TRS-type, balanced or unbalanced (ch 1~8)

2) Peak level: 0dBFS @ +6.5dBV (-10dBV nominal)

3) Impedance: 10k ohms minimum

4) Att. & Gain Control: -60dB ~ +15dB (0.5dB step size) *ch1, 2ch only

2. Analog Ouputs

1) Connector Type: 1/4" female TS-type, unbalanced (ch 1~8)

2) Peak level: +6.2dBV @ 0dBFS (-10dBV nominal)

3) Impedance: 100 ohms

4) Attenuation Control: -60dB ~ 0dB (0.5dB step size)

3. Mic Preamplifier

1) Peak level: 0dBFS @ -40dBV

2) Gain Adjustment: Gain +31dB up + -60 ~ +15dB (0.5dB step size)

3) +12V phantom power supply from PCI Card

+48V phantom power supply from RACK (XLR connector only)

4. Headphone Amplifier

1) Load Impedance Range: 32-300 ohm (for the best performance)

2) Output Power: 125mW @ 32ohm per channel

1. Internal 20ch /36-bit Digtal Mixer(Input 10ch/Output 10ch)

2. Sample rate supports: (22.05,24)*,32,44.1,48,88.2,96kHz : *analog only

3. A/D Converter

1) Signal to Noise Ratio: 107dB (A-weighted) @ fs=48kHz

2) Dynamic Range: 107dB (-60dBFS with A-weighted) @ fs=48kHz

3) S/(N+D)(-1dB): 100dB @ fs=48kHz

4) Interchannel Isolation: -110dB

5) Resolution: 24-Bit