User`s guide

ESI Communications Servers Administrator’s Manual Function 3: Extension programming

D.1

Function 3: Extension programming

This section provides programming for extensions and department groups.

Important: Where any gray shading (■) appears in an example, it represents values either unavailable to the function

or unused in the particular example.

Function 30: Station move

This feature allows the Installer or Administrator to exchange the extension numbers of two extensions. It is used

only for exchanging extensions — not guest mailboxes or departments.

Important: Before you use this function on two extensions, make sure they’re both idle at the time.

Along with the extension numbers, this function also will exchange the following parameters (depending on

station type):

• Extension name and other assignments (including of the Operator to extension 0 from Functions 31

and 32).

• Mailbox information (personal greeting, notification, schedules).

• Programmable feature keys.

• Personal Dex.

Function 30 has the following limitations:

• Mailboxes cannot be exchanged. Instead, the Installer must use Function 34 (flexible number assignment).

• Both extensions must be of the same “type” — i.e.., analog to analog, digital to digital, IP to IP — as shown in

the following table:

From . . . To . . . Function 30 allowed?

Digital phone Digital phone Yes

Analog extension Analog extension Yes

IP Phone (local or remote) IP Phone (local or remote) Yes

Digital phone Analog extension No

IP Phone (local or remote) Analog extension No

IP Phone (local or remote) Digital phone No

Fax, modem, door, ringer, server,

RFID Reader, SIP station, VIP Softphone

Any type of phone No

To use this feature:

1. Enter Installer programming through a Digital or IP Feature Phone and go to Function 30.

2. Enter the first extension and press #.

STATION MOVE

1ST EXT: 1044

3. Enter the second extension and then press #.

X1044 J SMITH

2ND EXT: 1056

(Continued)

Function 31 is accessible by only Installers.

Your installing ESI Reseller must use Function 34 to change the numbers of these types of extensions.