User`s guide

ESI C-Plus Administrator’s Manual System programming: An introduction
B.3
System programming overview
1 System parameters
13 Administrator password
14 System clock
141 Set time/date
142 Automatic time setting
143 Clock adjustment
17 System speed-dial
18 Maintenance/SMDR serial port
3 Extension programming
32 Extension feature authorization
5 Voice mail programming
53 Guest/info mailboxes
55 Message notification options
551 Station delivery options
552 Delivery/paging parameters
56 Cascade notification mailboxes
6 Recording
61 Record system prompts
62 Record directory names
63 MOH programming
631 MOH source
632 Record MOH
633 MOH volume
Entering programming mode
You may program from any 24-Key Digital Feature Phone
1
in the system (or a 48-Key Feature Phone on an ESI
C-Plus Executive system):
1. Press PROGRAM at any digital station. The normal station programming menu prompts will begin to play.
2. Press HOLD. The “enter password” prompt will play.
3. Enter the Administrator password (default is 4 5 6). Then, to confirm the password, either press # or wait
two seconds. You are now in programming mode. The extension will be automatically placed in DND,
and its display will show:
ADMINISTRATOR
CMD:
4. The system will play the system programming menu. Follow it to program as you wish.
5. When finished, hang up.
Warning: Always FINISH programming in ANY function BEFORE exiting programming mode (as needed, press # to
accept current entries for function parameters you’re not changing).
Note: The system will automatically exit programming mode after 10 minutes of inactivity.
Example: If your Administrator password is 468, enter programming mode by pressing PROG/HELP HOLD 4 6 8 #.
(To exit programming mode, hang up.)
1
Although a 12-Key Feature Phone allows you to enter Installer and Administrator programming, we don’t recommend that you use a 12-Key
Feature Phone for programming because of its one-line display and small number of programmable feature keys.