User`s guide

ESI C-Plus Administrator’s Manual Function 6: Recording
F.3
Function 632: MOH recording
1. Connect the message/music source to the MOH port on the side of the cabinet.
Note: The connector is monophonic-only — if you use a stereo source, you must either set it to output
mono, if possible, or use a stereo-to-mono conversion cable (or adapter).
2. Enter 594.
3. Press 1 to begin recording. To aid you in queuing, the source will be played through the phone’s speaker.
Note: The recorded material should not have a “beginning” or “end” — so that playback can loop continuously.
4. Press 1 when finished. The recording will play back so you can review it.
5. Press # to accept the recording.
Function 633: MOH volume
If a custom MOH is recorded, the output volume can be adjusted in this function.
Range: 1 (faint)–12 (loudest). Default: 6.
Notes: If an external audio source such as a radio is used for MOH, adjust the volume at the source.
To turn live MOH volume completely off, turn off volume at the source.
To turn recorded MOH volume completely off, select prompt 594, but make sure it’s blank.
This prompt is blank by default; if you have recorded some audio on it, just select it and record a
few seconds of silence.