Installation manual
ESI-50L Programming Manual Function 3: Extension programming
F.2
4. Both extensions will now appear in the display. Confirm the exchange by pressing #.
X104 J SMITH
X105 S BROWN
5. If one of the phones is in use, the display will show that extension:
STATION MOVE
EXT 104 BUSY
(If both are in use, the display will show only the first extension.)
To back up to the previous step, press
and then re-try the extension exchange by pressing # again.
Function 31: Extension definition and routing
Extensions can be either:
• Digital Feature Phone extensions
1
(DIGITAL in the chart below and succeeding charts)
• Analog ports (PHONE, FAX, MODEM, RINGER, or DOOR in the same charts)
Extension numbering
Extensions
Port card
Digital stations Analog stations
1 (main board) 100 through 107 108 and 109
2 110 through 117 118 and 119
3 120 through 127 128 and 129
4 130 through 137 138 and 139
Digital Feature Phones
Here’s an example of the portion of a completed programming worksheet for Digital Feature Phones.
1.
Ext.
2.
Type
3.
Name
4.
CO
5.
CF day
6.
CF night
7.
Page zone
8.
Ext.
0 Operator X100 X100 X100
100 DIGITAL Jane 9 MB100 MB100 0,1,2,3
101 DIGITAL Roger 9 MB101 MB101 0
102 DIGITAL Sally 9,8 MB102 MB102 0
108 EXT Roger 2 9 MB106 MB106
109 FAX FAX
Note: 100 defaults as OPR (when a user dials 0); 101 is an example of system default.
Each programming step for Digital Feature Phone extensions is defined as follows:
1. Extension number — Extension numbers range from 100 to the highest number of ports installed and
must match the port numbers as connected to the system.
2. Type — Based on the port card installed, the ESI-50L assigns the port as digital.
2
3. Extension name — Used for the display, reports, and as a programming aid. The name’s length can
be no longer than 10 characters (See “Entering alphanumeric characters,” page C.2).
Default: The extension number.
(Continued)
1
Includes ESI Presence Management RFID Readers. For more information, see the ESI Presence Management Installation Manual (ESI # 0450-0792).
2
For programming of analog ports, see pages F.4–F.4.