Installation manual

ESI-50L Programming Manual Function 1: System parameters
D.4
Function 16: System feature parameters
Function 161: Recording alert tone
This sets whether the system plays a short beep tone every 15 seconds during a call recording, indicating to
both parties that a recording is in progress.
Default: Disabled (the beep doesn’t play).
Important: IN MOST JURISDICTIONS, IT IS PERMISSIBLE TO RECORD A CONVERSATION IF ONE OF THE
TWO PARTIES IS AWARE THAT IT IS BEING RECORDED. HOWEVER, ESI TAKES NO
RESPONSIBILITY AS TO ITS LEGALITY IN ALL JURISDICTIONS. IT IS THE RESPONSIBILITY OF
THE INSTALLING COMPANY AND THE END USER TO DETERMINE AND FOLLOW THE
APPLICABLE STATE AND LOCAL LAWS REGARDING RECORDING OF CONVERSATIONS.
Function 162: Connect tone
This sets whether the system plays a system connect tone (two short beeps a user hears when a station answers).
Default: Enabled (the beep plays).
Function 163: Station feature set activation
Field 1: Group listen
With this feature disabled: if a station user presses SPEAKER while on a call, the Feature Phone
immediately turns off the handset and switches to hands-free mode.
If enabled, the group listen feature is available system-wide. If disabled, it is no longer available.
Default: Disabled.
Field 2: Privacy release
With this feature enabled: if a station user presses a CO line key that is in use (lit red), the user will be
immediately conferenced with the call in progress on that line. With this feature disabled, pressing an in-use
CO line key has no effect.
Default: Disabled.
Warning: Adjusting this parameter while calls are in progress may result in temporary loss of audio.
(Continued)