Installation manual

ESI-50L Programming Manual Function 1: System parameters
D.1
Function 1: System parameters
Function 11: Initialize
This function will return all components and software to their initial state. Initialization will erase all data and
custom recordings.
Important: Always initialize the system before initial programming for a new installation.
You must confirm the command to initialize, when prompted, by entering the Installer password.
BEFORE initializing, be sure to set the time and date (Function 14).
System initialization will take approximately one minute to complete. When initialization is complete, the phone’s
display will return to the idle state. You must then re-access Programming Mode by following the steps
described earlier (see page C.3).
Functions 12 and 13: Installer and Administrator passwords
These functions will display the existing password and prompt for entry of a new password. The passwords can
be 2–8 digits long, followed by #. The Installer can change either the Installer or Administrator Password.
Only those functions listed in the Administrator manual can be programmed via the Administrator
Password. The default passwords are:
Installer password (Function 12) = 7 8 9
Administrator password (Function 13) = 4 5 6
Note: Be sure to write down the new passwords, store them in a safe place and give the new Administrator’s
Password to the Administrator.
Accessing user station programming
Should a user forget his password or if an employee leaves the organization, this feature allows the Installer
or Administrator to enter a user's station programming and operate within it as if he were the user. From the
user’s station, enter the Installer or Administrator password when the system prompts for the user password.
Example: From station 105, entering 7 8 9 # or 4 5 6 # instead of the user password (1 0 5 #) will enter the station’s
user programming. (Default passwords shown for this example).