Installation manual

ESI-50L Programming Manual System programming: An introduction

C.4

Entering programming mode

You may program from any 24-Key or 48-Key Digital Feature Phone

in the system:

1. Press PROGRAM

at any digital station. The normal station programming menu prompts will begin to play.

2. Press HOLD. The “enter password” prompt will play.

3. Enter the Installer password (default is 7 8 9).

Then, to confirm the password, either press # or wait two

seconds. You are now in programming mode. The extension will be automatically placed in DND, and

its display will show:

4. The system will play the system programming menu. Follow it to program as you wish.

5. When finished, hang up.

Warning: Always FINISH programming in ANY function BEFORE exiting programming mode (as needed,

press # to accept current entries for function parameters you’re not changing).

Note: The system will automatically exit programming mode after 10 minutes of inactivity.

Example: If your Installer password is 864, enter programming mode by pressing PROGRAM HOLD 8 6 4 #. (To exit

programming mode, hang up.)

Although a 12-Key Feature Phone allows you to enter Installer and Administrator programming, we don’t recommend that you use a 12-Key

Feature Phone for programming because of its one-line display and small number of programmable feature keys.

Or, if using the 24-Key Feature Phone, press PROG/HELP.

If you prefer to enter Administrator programming mode, use the Administrator password, instead (the default is 4 5 6).