User`s guide

Special keys User’s Guide
F.2
Auto-dialing using Esi-Dex
1. While your station is idle (or just after receiving dial tone), repeatedly press ESI-DEX to select the
desired Dex:
2. Choose the desired name from the selected Dex, using one of the two following methods:
Press repeatedly ... To ...
▼ or ▲ (scroll keys)
Scroll through all names in the list from the beginning or end
(A dialpad key) Scroll through only the names that correspond to the three letters on the key
3. When the desired name and number appears . . .
. . . press ESI-DEX again to dial the number.
Adding names to your Personal Dex
You can add names to your Personal Dex by using either the Caller ID method or the manual method.
Caller ID method
Whenever a Caller ID name appears on your phone’s display while you’re talking on an incoming call or
retrieving a message, press ESI-DEX to automatically store the name and number in your Personal
Dex. The display confirms:
Manual method
While your station is idle, press ESI-DEX until prompted to “ADD-A-NAME” . . .
. . . and then enter the name and the number as prompted.
Note: If needed, press PROG/HELP for assistance.
1. To enter each character for the name, press the dial pad key that includes the desired character.
The key’s possible character entries will change each time you press the key.
2. When the desired character appears, press # to confirm its entry. The cursor will move to the next
character position. Use ▼ and ▲ (the scroll keys) to back up or to insert a space.
Example: To enter a B, press 2 twice (the possible options through which to scroll are A, B, C and 2). When
B appears, press # to confirm and move to the next entry.
3. Repeat steps 1–2 until the name is complete. The name may contain up to 15 characters (a space
is a character, too).
(Continued)