Owner Manual

IMPORTANT
1. This power supply driver contains high-pressure with
irreplaceable spare parts. Do not open if you are a non-
professional.
2. Keep power transformer away from children regardless whether
the power supply is in use. Do not use in an explosive
environment.
3. As this driver is a high-frequency PWM energy-saving control
mode and its operating frequency is 50-70 KHZ, please keep
away from AM radio, speakers, electron transistor scanning
monitor and other radio sensitive equipment when use.
4. Protect from water. For locations that could be exposed to rain
or splashing water, install the driver in a suitable wet location
power supply enclosure.
Input Connection
Remove 2 screws and protective cover at the side marked “AC
IN”.
With power turned off, route the input wires through a strain relief
and connect AC live wire to port “L” and connect the AC neutral
wire to port “N” (see Pic.1)
Place protective cover on side marked “AC IN” and use screws to
fasten it.
Output Connection
Output cable already preinstalled for you. [Output Connector
specification] 3.5mm (Outer Diameter) x 1.35mm (Inner Diameter).
Once you have input connection set and power is on. You can
connect cable to the LED bar.