Installation manual

29
10. Appendix A. ESETS setup and configuration
10.1 Setting ESETS for scanning of HTTP communication - transparent mode
HTTP scanning is performed using the esets_http daemon. In the [http] section of the ESETS configuration file, set the following
parameters:
agent_enabled = yes
listen_addr = "192.168.1.10"
listen_port = 8080
In the example above, ‘listen_addr’ is the address of the local network interface named ‘if0’. Restart the ESETS daemon. The next
step is to redirect all HTTP requests to esets_http. If IP-filtering is being performed by the ipchains administration tool, an
appropriate rule would be:
ipchains -A INPUT -p tcp -i if0 --dport 80 -j REDIRECT 8080
If IP-filtering is being performed by the iptables administration tool, the rule is:
iptables -t nat -A PREROUTING -p tcp -i if0 --dport 80 -j REDIRECT --to-ports 8080
On FreeBSD, the rule is:
ipfw add fwd 192.168.1.10,8080 tcp from any to any 80 via if0 in
On NetBSD and Solaris, the rule is:
echo 'rdr if0 0.0.0.0/0 port 80 -> 192.168.1.10 port 8080 tcp' | ipnat -f -
10.2 Setting ESETS for scanning of FTP communication - transparent mode
FTP scanning is performed using the esets_ftp daemon. In the [ftp] section of the ESETS configuration file, set the following
parameters:
agent_enabled = yes
listen_addr = "192.168.1.10"
listen_port = 2121
In the example above, ‘listen_addr’ is the address of the local network interface named ‘if0’. Restart the ESETS daemon. Then,
redirect all FTP requests to esets_ftp. If IP-filtering is being performed by the ipchains administration tool, an appropriate rule
would be:
ipchains -A INPUT -p tcp -i if0 --dport 21 -j REDIRECT 2121
If IP-filtering is being performed by the iptables administration tool, the rule is:
iptables -t nat -A PREROUTING -p tcp -i if0 --dport 21 -j REDIRECT --to-ports 2121
On FreeBSD, the rule is:
ipfw add fwd 192.168.1.10,2121 tcp from any to any 21 via if0 in
On NetBSD and Solaris, the rule is:
echo 'rdr if0 0.0.0.0/0 port 21 -> 192.168.1.10 port 2121 tcp' | ipnat -f -
10.3 Setting ESETS for scanning of ICAP encapsulated HTTP messages
ICAP encapsulated HTTP message scanning is performed using the esets_icap daemon. In the [icap] section of the ESETS
configuration file, set the following parameters:
agent_enabled = yes
listen_addr = "192.168.1.10"
listen_port = 1344
In the example above, ‘listen_addr’ is the address of the local network interface named ‘if0’. After adding these parameters,
restart the ESETS daemon.