Use and Care Manual
EE Systems Group Inc. www.eleding.com , info@eesgi.com. 1-877-579-3889 (M-F, 10am-5pm PST), v062019
If you need to use both hand-hold controller and wall controller for the
same light, please don't use this function, directly use the following copy
function.
2.4G Wireless Dimming & CCT Tunable Remote Controller
THE WALL TYPE REMOTE CONTROLLER
Power the light off then power it on, the last saved brightness (which is saved by the button "ON") and the last saved color
temperature (which is saved by the button "ON" or "OFF") will be displayed by default. The defaulted factory setting of the
light is 100% brightness and 4000K.
After 10s of each operation the controller will enter standby power saving mode. If you need to make adjustments, simply
press the "ON" button, the indicator will flash to show it is working. (If the controller is under working mode, the indicator
will flash no matter which button is pressed).
The matching method of hand-hold remote controller and wall-type remote controller, the wall
controller can copy some of the functions of the hand-hold controller by the following method.
1
2
3
4
NO Grouping Hand-hold controller Wall-type controller
5
1
2
3
4
ALL
1+ID
2+ID
3+ID
4+ID
ID
ON+CCT
ON+CCT
ON+CCT
ON+CCT
ON+CCT
A
Initial code learning between light and remote to activate the unit
Built on RF remote dimmer (w/o any additional wirings & dimmer)
Turn the wall hardwired switch/circuit breaker OFF, press-hold ON & OFF buttons together till
RED LED flashing on top of the remote; turn ON the wall switch/circuit breaker, release buttons
after panel light(s) flashing
Keep momentary pressing this button to select color temps between 3000K to 5000K in
cycle
A
+
Turn on Turn off
It has much flexibility for selecting dimming & color temp change. Can fit in a 1-gang box as
wall switch for small individual/partition area or lighting cover area w/o hardwired switch &
standard dimmer but circuit breaker is recommended if available for the setting up
Dual functions:
1. Momentary press to ON the light as normal;
2. Press and hold few seconds until lights shut OFF to SAVE the pre-setting profile for operating
Momentary press it to shut OFF the light