Use and Care Manual

EE Systems Group Inc. www.eleding.com , [e-mail]. 1-877-579-3889 (M-F, 10am-5pm PST), v062019
2.4G Wireless Dimming & CCT Tunable Remote Controller
THE HANDHELD REMOTE CONTROLLER
Turn on
Initial matching the code between light(s) and remote to activate
operate by the remote controller
Erase the existing code for resetting up
Group lights Setting up
Save pre-set brightness level and color temp
Turn the wall hardwired switch/circuit breaker OFF, press and hold the ID
button until a tiny RED LED indicator is flashing on top of the remote then
turn ON the wall hardwired switch/circuit breaker, and release the ID button
after panel light(s) flashing
After Initial matching the code between light(s) and remote, this handheld
remote allow to use up to four groups (1; 2; 3; 4) in selecting use: Turn the
grouping wall hardwired switch/circuit breaker OFF, following press the group
selection button for few seconds, then turn ON this group of lights, release
the group button after group lights flashing. Do the same for other groups.
5000K
4000K
3500K
25% brightness
Increase brightness Decrease color temperature
Increase color temperatureDecrease brightness
50% brightness
75% brightness
100% brightness
3000K
All Groups are selected
Turn off
Save
+
Turn the wall hardwired switch/circuit breaker OFF, then press and hold the
button together for couple seconds, following turn the wall
hardwired switch/circuit breaker ON, release the buttons after panel light(s)
flashing
+
Press and hold the SAVE button for few seconds until the lights shut OFF with
your pre-set brightness and color temp, then settings are saved. Now wall hardwired
switch works as normal function with pre-selected lighting profile, also applicable for
group setting
Remote controller provides users most flexibility adjustment for smoothly dimming
and selecting color temp, the standard wall mount hardwired switch is highly
recommended as primary ON-OFF control for normal operation in most case
Once select satisfied setting by remote control, it will be saved with ON-OFF
in remote control use until next setting change
Power the light off then power it on, the last saved brightness (which is saved by the button "SAVE")
and the last saved color temperature (which is saved by the button "SAVE" or "OFF") will be displayed
by default. The defaulted factory setting of the light is 100% brightness and 4000K.
5000K 4000K 3500K 3000K
COLOR(CCT)
BRIGHTNESS
GROUPING